^{*}

The heat capacity of some ferrimagnets has additional structures like a shoulder in the Schottky-like peak, or emergence of a second peak when an external magnetic field is applied. It is shown here that the ferromagnetic and anti-ferromagnetic elementary excitation spectra give rise to two independent heat capacity peaks, one enveloped by the other, which add up to give the peak for the total system. Taking this into account helps understand the additional structures in the peaks. Moreover, the classification of ferrimagnets into predominantly antiferromagnetic, ferromagnetic, or a mixture of the two is shown to be validated by studying them under additional influences like dimerization and frustration. Because these two are shown to influence the ferromagnetic and antiferromagnetic dispersion rela tions—and hence the quantities like heat capacity and magnetic susceptibility—by different amounts, the characterization of ferrimagnetic systems (1,1/2), (3/2,1) and (3/2,1/2) is brought out more clearly. Both these influences enhance antiferromagnetic character. PACS numbers: 75.10.Jm, 75.50.Ge.

Thermal properties of ferrimagnetic chains were theoretically investigated recently employing various methods like the modified spin-wave theory (MSWT) [1-4], density matrix renormalization group (DMRG) [2,3], quantum Monte Carlo method (QMC) [1,2,5], and Schwinger boson mead field theory (SB) [

Ferrimagnetic systems have been classified into three categories: one with a predominantly Ferromagnetic (F) character, the second with a predominantly antiferromagnetic (AF) character, and the third with a mixture of the two. If the two spins constituting a ferrimagnet are and with, then it is conjectured [9,10] that the systems in the first category are those with, those in the second category have, and the systems in the third category have. We call it Yamamoto classification. Thus the system () is ferromagnetic in character, () is antiferromagnetic, and () has a mixture of the two characters.

The vs temperature curves of different ferrimagnetic systems look alike—a rapidly decaying ferromagnetic part at low T, a rounded minimum at intermediate T and a linearly increasing antiferromagnetic part at high T—except that some systems like the predominately ferromagnetic () have a smaller rate of increase with temperature after the minimum compared to others. The heat capacities of the three systems also have quailtatively the same shape: a dependence at low T, a Schottky-like peak and a decay at large temperatures. The MSW results on () system, however, show a shoulder in the heat capacity below the peak temperature, which has been explained as being a result of the deficiency of the theory [11,12]. When an external magnetic field is applied, a second peak appears at low temperatures [

In a recent work [

There were two distinct values of the frustration parameter; the transition point, that heralds transition from a commensurate ferrimagnetic state to a spiral state and the disorder value at which the energies become imaginary. The heat capacity and susceptibility are also expected to show the telltale signs of the transition induced by.

Linear spin wave theory is known to give a fair picture in the case of ferromagnetic chains and gives only a qualitative picture for antiferromagnetic chains [11,12]. It has also been shown that it gives sufficiently good results for a ferrimagnetic system [15-18]. In a frustrated system, it has already been argued that the LSW theory yields satisfactory results at least in the limit of small frustration [

In this paper we will study alternating spin systems formed with spin values () using linear spin wave theory. We investigate the temperature dependence of specific heat and susceptibility. We would like to see how the predominantly ferromagnetic, antiferromagnetic or mixed characters of the systems are brought out by subjecting them to dimerization and frustration. In particular, we would like to see the effect of the frustration-induced ferrimagnetic-to-spiral state phase transition on heat capacity and magnetic susceptibility. It is suggested that such peculiar effects will help identify the presence or absence of spin-Peierls dimerization and frustration in real low-dimensional ferrimagnetic systems.

We consider a chain with spins and () sitting on alternating sites with the possibility of lattice distortion leading to dimerization, and of competing antiferromagnetic nearest and next nearest neighbor couplings, and respectively. A two sublattice model of this system may be described by the Hamiltonian

with belonging to one sublattice containing spins and to the second sublattice containing spins. The interaction describes the alternate weaker and stronger couplings between two adjacent sites that may come about because of a spinPeierls dimerization of the lattice. is the dimerization parameter. The degree of frustration is given by the ratio

In the standard linear, non-interacting spin wave analysis, the above Hamiltonian is written in terms of bosonic spin-deviation operators with the help of HolsteinPrimakoff transformations, linearized and then diagonalized in terms of normal mode operators to

The ground-state energy per unit cell and the energies of the two excitation modes and are given by

In these equations

where, is the frustration parameter and runs from to which is the first reduced Brillouin zone.

The free energy of the system is

where and are the bose distribution functions for the two modes. It was reported earlier that the free energy decreases with increasing temperature [

The static susceptibility is

where. The product shows a minimum at intermediate temperatures, indicating that both the ferromagnetic and antiferromagnetic modes coexist in ferrimagnets.

Specific heat has a Schottky-like peak. In a textbook two level system, the peak is a result of the gap, and an increase in this gap makes the peak shift to higher values of temperature, and a decrease makes it shift to lower values.

A ferrimagnet has two low lying excitations, one ferromagnetic in character (the acoustic dispersion) and the other antiferromagnetic (the optic dispersion curve). The Schottky like peak in the heat capacity is understood to be due to the two dispersion curves. In principle, because of the two excitation dispersion curves, one would expect this to behave like a three level system. But the heat capacity of a ferrimagnet does not follow the pattern of a 3 level system. Instead, from the non-interacting spin wave theory results of ferrimagnets, the contributions of the ferromagnetic and antiferromagnetic dispersions to the heat capacity of a ferrimagnet seem to be additive. The heat capacities calculated for the modes separately has each a Schottky-like peak structure, and the two add up to give the heat capacity of the ferrimagnet. This is also expected from the fact that in the absence of spin wave-spin wave interactions, the free energy is a sum of the ferromagnetic (F) and antiferromagnetic (AF) normal mode energies, as in Equation (12). The F and AF heat capacity peaks, which have the usual and dependence, respectively, at low temperatures, are mostly overlapping due to which the resultant heat capacity has a single peak. The additive nature of the two contributions is also reflected in the dependence of susceptibility on temperature. With increasing temperature, the ferromagnetic contribution decays earlier, while the antiferromagnetic one increases and persists up to higher temperatures [1,2,4,6-8,20,21].

The behavior of these physical quantities with temperature in the presence of dimerization and frustration parameters for different system (); (), and (), shall be discussed below. The effect of dimerization alone is discussed in section III, and that of frustrating alone in section IV.

The effect of dimerization on the heat capacity of the (1,) ferrimagnetic chain which is supposed to have a mixed F and AF characters is shown in

the two. The F peak shifts by a larger amount than the AF peak, and the magnitude of the AF peak increases with while that of the F peak decreases. This is true for the other two ferrimagnetic systems () and () also, and appears to be a universal feature of a ferrimagnet, be it predominantly F, AF or a mixture the two characters. The increase and decrease in the AF and F peak magnitudes clearly shows that dimerization increases the antiferromagnetic character and decreases the ferromagnetic one. The net effect of this different effect is the emergence of the second peak in the total heat capacity, and a decrease in the magnitude of the main peak for the (1,) system, as shown in the inset. The predominantly F system () has this effect so accentuated that the shoulder, which in the LSW and MSW analyses is present even at, turns into a double peak, as shown in

The shift of the peaks to lower temperatures can be understood in terms of the energies of excitation. The heat capacity peaks are indeed Schottky-like peaks in that they are a result of the gaps in excitation spectra. The Schottky peak in the heat capacity of a simple textbook two-level system with a gap between the two levels has a position that shifts with the magnitude of. As decreases, it shifts to lower temperatures, and vice versa. For a ferrimagnetic chain, contribution to the peak comes from all the modes which have well-defined dispersions in k-space, each mode having a different gap. With dimerization, the dispersion curves are lowered in energy, giving rise to a shift of the peak to lower temperatures.

That the shifting is a result of the changes in the excitation spectra is also supported when the effect of dimerization on heat capacity is calculated by using a different parametrization of dimerization. We had earlier introduced as another possibility [14,22]. The reasons are given in that reference. This parametrization has an opposite effect on the dispersion curves. Instead of decreasing in energy with as in the case of the usual, the dispersion curves are now pushed up in energy with increasing, with a nonlinear dependence on.

The change of character upon dimerization shows up in the susceptibility of ferrimagnets also.

The effect of frustration in ferrimagnetic systems has been investigated [4,14,17] at zero temperature. Two key values of the frustration parameter were identified; namely, and. At any finite temperature, we find that within the linear spin wave theory the two are temperature independent. We will study the thermal effect of a frustrated chain in the absence of dimerization.

The effect of frustration on heat capacity will again be discussed for the F and AF contributions separately. Frustration causes the AF peak to slightly increase in size and shift to lower temperatures. But its effect on the peak due to the F excitation modes is more dramatic. Here the transition to the spiral phase at has its impact. Before the peak decreases in size and shifts to lower temperatures. Beyond this value, when the system goes into the spiral phase, a further increase in frustration causes the peak to increase in size and shift to higher temperatures. All of this is a result of the modesoftening changes that the F dispersion curves go through, as seen in

In the case of the () system, the chain having a mixed F and AF characters, the curve has an AF-like dependence at low temperatures. With added frustration, the F peak separates out at low temperatures making the total curve have an F-like dependence at low T. The F peak diminishes in size with increasing, almost vanishing at, beyond which it regrows and eventually merges with the AF peak. At this point the curve again has an AF-like dependence at low temperatures. This is shown in

In the case of the predominantly F system (), the heat capacity of which has a low temperature shoulder due to the F peak even in the absence of frustration, the changes affecting the F peak are very prominent, as in

In the case of the predominantly AF system (), the F peak in itself experiences the same changes as in the () system, but it remains submerged in the AF peak, and the net never shows a second peak, as in

The effect of frustration on is the same as that of dimerization. The minimum shifts to lower temperatures and the slope of the high temperature tail increases as shown in

In short, the effect of dimerization and frustration on the thermal behavior provides a nice evidence of the validity of the Yamamoto classification of ferrimagnetic chains.

We thus conclude that the heat capacity of a ferrimagnet can have a more complicated structure than a simple Schottky-like peak. It can have a low temperature shoulder or a double peak structure. The peak can shift to lower or higher temperatures and can also change in size depending upon the influences the system is undergoing. All of this can be understood in terms of the component ferromagnetic and antiferromagnetic peaks that retain their individuality. The Yamamoto classification of the ferrimagnetic systems into predominantly ferromagnetic (), antiferromagnetic () and ferrimagnetic () appears to have a basis in this characteristic.

The author would like to thank Wu Congjun for discussion and help.