New Sohag City has an area of approximately 1300 acres (546 hectares) and is located within Sohag Governorate limits, about 18 km away from old Sohag City. It is established to reduce the population within the old Sohag city and to create better economic conditions in a new appropriate living environment. The main target of this study is to apply the relevant surface geophysical methods to image the shallow subsurface setting, to define the shallow lithological layers and to locate any geological structures that may be cause cracks in buildings, and any unstable materials, which may decrease the bearing capacity or human activities, hence increasing hazards in the study area. This study embraces, Electrical Resistivity Tomography (ERT), Shallow Seismic Refraction (SSR), and Ground Penetrating Radar surveys (GPR). The integrated interpretation of all techniques classified the subsurface layers into two layers. A strong reflector separating the upper gravel and calcareous sandy layer from the lower clayey layer. They gave also interesting information about the geotechnical competent of the ground and some structural features in the study area.
Sohag Governorate is located at 467 km south of Cairo. The Red-Sea and New Valley Governorates are the eastern and western boundaries of Sohag Governorate, respectively. Old Sohag city occupies a region including both the floodplain and the desert fringes between latitudes 26˚00'N and 27˚00'N and longitudes 31˚15'E and 32˚15'E. The Nile flood plain soil extended along the two banks of the River Nile for about 10 km. contrarily, it constitutes only a very narrow strip along the eastern side.
New Sohag City (Akhmim Center) utilized three geophysical surveys: Electrical Resistivity Tomography “ERT”, Shallow Seismic Refraction “SSR”, and Ground Penetrating Radar “GPR” to delineate any structural features, and characterize of the nature of the foundation materials.
Geologically, many authors have studied the area (e.g. [
including the study area [
Paleogene sediments and narrow cultivated stretch bordering the Nile River cover most of the area under investigation. This cultivated land has been formed through the flood season of the river Nile since a long time to form the Nile sediments (Pleistocene and Recent deposits).
Several attempts have been done by several authors to discuss the stratigraphy of the Nile Valley, such as (e.g. [
The stratigraphic section of new Sohag city, Akmim center has been studied and described as shown in
The utmost constraint of the resistivity sounding method is that it does not take into consideration the horizontal changes in the subsurface resistivity. The ERT
survey conquers this problem, where the resistivity changes in the horizontal direction as well as in the vertical direction along the survey line. Therefore, ERT technique selected for this survey. While, the Wenner array gives the smallest number of possible measurements compared to the other common arrays [
The geo-electrical data is collected along thirteen parallel (ERT) profiles using the Wenner electrode arrangement with maximum spread of 160 m, 5 m spacing between the electrodes and 10 m interline distance using the SYSCAL R2 system. Through the ERT survey, the penetrated depth reaches about 20 m. A built-in microcomputer together with an electronic switching unit is used to automatically select the relevant four electrodes for each measurement as shown in
Seismic exploration involves generation of seismic waves and recording the arrival times of these waves from the source to the series of geophones [
Twenty-six seismic refracted profiles (forward and reverse shots) acquired using an exploration seismograph model “DOLANG-Italy”. Thirteen profiles for (P-wave) and thirteen profiles for (SH-wave) conducted parallel to the north direction of the study area as shown in
Ground penetrating radar (GPR) is a high-frequency electromagnetic technique;
commonly applied to solve most of the engineering and environmental problems. A GPR system radiates short pulses of high-frequency EM energy into the ground from a transmitting antenna. The velocity of EM waves is related to the dielectric permittivity of subsurface materials. When this wave encounters the interface between two materials having different dielectric permittivity, a portion of the energy is reflected back to the surface, where it is detected by a receiver antenna and transmitted to a control unit for processing and display.
Depth of penetration of radar waves is a function of antenna frequency, dielectric constant and the electrical conductivity of the soils. However, low-fre- quency antennas achieve greater depth of penetration than those of high frequency, but they have poor spatial resolution. Conductive soils, such as clays, attenuate the radar waves much more rapidly than resistive soils such as dry sand and resistive rock [
A raw estimation of depth is obtained by multiplying the one-way travel time with the average propagation velocity of the GPR pulse inside the geological formation. The GPR method has been increasingly used for shallow subsurface mapping because of its capability to provide a high-resolution image of the near surface discontinuity and heterogeneity [
Thirteen GPR profiles have been acquired using RAMAC instrument with 100 MHz antenna; their lengths are 250 m. The conducted GPR profiles is measured at the same location of the conducted (ERT) and (SSR) profiles as shown in
The Conducted ERT data were processed using RES2DINV program package edited in 1998, [
The ERT data were used to provide the distribution of electrical properties in the subsurface soil, to outline the high resistivity zones that could be attributed to the hard and dry calcareous sand, and to outline the low resistivity zones attributed to silty clay soil and water saturated soil.
The inspection of the conducted ERT profiles, two major geoelectric layers could classified as the following
・ The top layer exhibits a moderate resistivity values ranging from 101 Ohm・m to 410 Ohm・m with average thickness of 5.0 m along all the conducted profiles. The ERT results correlation with the geologic information displays that this layer classified as gravel accumulation imbedded into the calcareous sandy layer.
・ The bottom layer underlies the top layer which extended down to the end of the ERT sections is characterized by low resistivity values ranging from 15.7 Ohm・m to 39.8 Ohm・m with thick thickness extends to the end of the profiles. This low resistivity value is due to the presence of silt/clay layer intercalation that extends with different lengths and thickness in all the surveyed profiles as shown in Figures 5-8.
The computer software (SEIS-REFA) program is used for estimating the parameters of the time-distance curve (X-T) curves and their corresponding depth-
velocity models. Figures 9-12 are showing example of travel time-distance curves and their depth-velocity models for the two conducted seismic profiles (P3 and P7) for (P-wave) and (SH-wave), respectively.
The Shallow seismic refraction (SSR) was applied to spectacle the areal distribution of the seismic velocities along the study area. The resultant seismic velocities will reflect the condition of solidity of the subsurface soil.
The inspection of the conducted seismic refracted profiles reveals the presence of two geoseismic layer according to their geoseismic velocities as follows:
・ The first geoseismic layeris represented in the all conducted seismic Profiles as shown in Figures 9-12 with slightly variable thickness. It is characterized by P-wave and SH-wave velocities ranging from 800 - 1200 m/s, and 650 - 900 m/s respectively. This layer shows symmetrical thickness across the seismic profiles with an average thickness of 3 m. This layer could be attributed to Calcareous sand (surface layer).
・ The second geoseismic layer follows the surface layer with high seismic velocity for P-wave and SH-waveranges from 2000 - 2600 m/s, and 1800 - 2100 m/s respectively. This layer is extending till the end of the section. This layer is corresponding to hardsilty clay.
The data are processed by using Reflex-win program, which operates under windows environment.
Only one reflector can be seen on the resulted GPR profiles. This reflector
interpreted as the contact surface between the upper gravel and calcareous sand layer and the lower clay layer. The nature of the clay reflections changed from place to place in the study area, which can be interpreted as the presence of different type of clays, most probably due to difference in saturations.
The attenuation of the electromagnetic waves increases with material conductivity. Materials that have high attenuation include clays, silts, shales and seepage
water, while which have low attenuation include distilled water, air, dry sand and ice.
Electromagnetic waves penetrate to almost 5 m subsurface (surface layer) until reached to the clay layer that attenuating the waves and masking other layers underneath.
Electrical Resistivity Tomography (ERT), Shallow Seismic Refraction (SSR), and Ground Penetrating Radar (GPR) measurements were conducted over the same area at a new Sohag city (Akhmim Center), Egypt to image the shallow subsurface setting and locating any geological structures that may cause obstacles for the new community creations.
The ERT, SSR, and GPR data were collected along 13 parallel profiles distributed along the available places to investigate the shallow subsurface medium, identify the lithologic units and to outline the clayey zones that have a hazardous effect on the foundation and construction processes.
The interpretation of all the conducted geophysical methods exhibited that the reflector interpreted as the contact surface between the upper calcareous sand layer and the lower silty clay layer. This reflector is well identified from the conducted three tools.
The lower clayey layer that highly identified by its high conductivity from ERT measurements and its highly ability of attenuating the electromagnetic waves from GPR measurements, should be taken into consideration when planning and designing the new Sohag city.
The integrated results obtained from the interpretation of the ERT, the SSR and the GPR records conducted over the study area classified lithologically into calcareous sandy, hardsilty clay layers. These layers are identically consistence with the typical lithological section of Akhmim Center [
The hazardous effect of the delineated clayey formations can be generated in case of water leakage, which may come from surface irrigation and/or defect in sanitary systems. The nature of the clayey layer is changed from place to place in the study area, which can be interpreted as the presence of different types of clays, most probably due to the difference in degree of saturations.
Mesbah, H., Shokry, M., Soliman, M. and Atya, M. (2017) Integrated Geophysical Investigations to Detect the Shallow Subsurface Settings at New Sohag City, Egypt. International Jour- nal of Geosciences, 8, 364-377. https://doi.org/10.4236/ijg.2017.83019