The Ionising irradiations used mostly in the treatment of tumoral diseasses are: X, γ, β and e irradiations. The discussion will be about γ irradiations, produced in linear accelerator with photon energy 6 MV and 15 MV. It is important to know the absorption performance before and after the electronic equilibrium. This is a reason that we’ve used the function of dose gradient for irradiations γ. It represents the velocity of dose change as a function of depth in tissue. From skin to maximum dose value, the increase of G-function is more accentuated for γ-rays than for β-particles while after that the G-function decreasing is less sharp for γ-rays. Finally, we’ll discuss about the advantages in terms of radiation protection of γ-rays used in radiotherapy.
When an irradiationbeam passes from a point A to an other point B, the energy of beam changes from E1 to E2. The difference
As we can see, this mathematical function means the rate or the velocity of beam’s energy reduction (de- creasing). This dosimetric quantity expressed in math’s terms is investigated in this work to increase the beam’s irradiation efficiency, as much as possible to the tumoral cells, protecting at the same time the healthy tissues and organs near and around [
The main characteristics of G-function for γ-rays are: on the first impact in skin surface, the production of the ions is intensive, to the drastic change of air to tissue density. Nevertheless, almost the half of ions go back or scattered back, while the parts which continue their paths inside, continue the ionisation. But now, together with the negative part of ions, the electrons can already cause a supplementary, more intensive ionisation, like electrons. Electrons created in the first millimeters of tissue, increase the number of electron’s interactions, while the decrease is by exponencial law with a normal impedance, which depends from the energy of γ-rays, as well as by the tissues density. G-function would be an increasing function up to a depth, which depends by the γ- photon’s energy, where the electrons lose their energy and G-function begins to decrease. The zone where G-function changes the sign, from increasing to decreasing function, or mathematically from positive values to negative values, is the zone where the number of created secondary electrons is equal with the number of absorbed one, for any unit of time. Do to the relative low intensity of γ-rays interactions behind this zone, and do to fast absorbtion of secondary electrons, γ-rays continue its path in health structures, giving unnecessary irradiation to there [
Material is took of from the every day typical treatment cases,using the real data of patients. In
The generating energies, are less or more of nearlythe same valueswithin the possibilities available in our institution. This, I think is necessary to do the comparison more credible. As we can see, the first part of curve, that from the skin to the maximal value(which is took as 100%), increase a litle bit fastly.
The total G-function determined from maximal values to value zerowill be ecxtremely higher, because the value zero in this case is not reached or as is accept to speak, is reached in infinit.Qualitatively, these two values can’t be paragonate and for these reasons, in generally are paragonate the values of 80% or/and 50%. The second value, i.e. 50% will be: 50%/160mm = 3.125%/cm. As we can see from
The depth, which in the case of cobalt-60 photons is 5 mm, in the similar energy photons produced in accelerator is 16 mm. For the PDD distribution dependence of isodose curves from energy, we can see in
The most important discussion’s argument to keep in mind is:to do maximal caution, necessary to realise the quality assurance(QA) treatment, to perform a correct treatment, being this one always more than necessary. This becomes more important, even imperative, because the treatment is based in high energy radiations, which, if they are used without necessary precaution and attention, can becomes not efficient, or even dangerous for the patient. To avoid such kind of accidents, it is more than necessary to do a good simulation, and after this to do the controls for any patient, simulating in detailsevery step, before the treatment itself. All parameters must be controlled, using an highly exact quality controll, an exact simulation of individual characteristics of each patient.
From the skin to the maximal value of PDD for the same beam size, energy etc., the G-function of irradiation is almost the same. The G-function, after the maximal dose value, is a descending function for γ-rays. This enables almost perfectly the protection of behind tumor structures.
I gratefully acknowledge the staff of Institute of Oncology in Kosovo, especially the staff of physicists in Department of Radiotherapy.
Labinot Kastrati,Gazmend Nafezi,Gëzim Shehi, (2016) The Gradient of γ-Rays Irradiation’s Energy and Its Use in Treatment of Cancer Diseases. International Journal of Medical Physics, Clinical Engineering and Radiation Oncology,05,150-153. doi: 10.4236/ijmpcero.2016.52016